Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 06.07.2019 02:30
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
You know the right answer?
Magelis HMI support TIME data type....
Questions
Spanish, 25.01.2021 02:10
Social Studies, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
History, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Mathematics, 25.01.2021 02:10
Law, 25.01.2021 02:10
