Engineering, 02.12.2020 18:40 Selen13
3. Determine the force in each member of the truss and state if the members are
in tension or compression.
2 m
20
6 KN
rtical
KN
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
Engineering, 06.07.2019 03:30
The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.
Answers: 2
You know the right answer?
3. Determine the force in each member of the truss and state if the members are
in tension or compr...
Questions
Biology, 08.04.2020 23:06
Mathematics, 08.04.2020 23:06
Mathematics, 08.04.2020 23:06
English, 08.04.2020 23:06
Mathematics, 08.04.2020 23:06
Chemistry, 08.04.2020 23:07
Mathematics, 08.04.2020 23:07
Biology, 08.04.2020 23:07
Mathematics, 08.04.2020 23:07
Physics, 08.04.2020 23:07
