subject
Engineering, 29.11.2020 16:40 Jerrikasmith28

If an aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well insulated. A special, thin coating is applied to the top surface such that it absorbs 80% of any incident solar radiation, while having an emissivity of 0.25. The density p and specific heat c of aluminum are known to be 2700 kg/m3 and 900 J/kg K, respectively. (a) Consider conditions for which the plate is at a temperature of 25 C and its top surface is suddenly exposed to ambient air at T=20 C and to solar radiation that provides an incident flux of 900 W/m2 . The convection heat transfer coefficient between the surface and the air is h = 20 W/m^2 K. What is the initial rate of change of the plate temperature?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
question
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 06.07.2019 02:30
Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.
Answers: 3
You know the right answer?
If an aluminum plate 4 mm thick is mounted in a horizontal position, and its bottom surface is well...
Questions
question
Mathematics, 12.10.2020 16:01
question
English, 12.10.2020 16:01
question
English, 12.10.2020 16:01
question
Mathematics, 12.10.2020 16:01
question
Mathematics, 12.10.2020 16:01
Questions on the website: 13722363