Engineering, 25.11.2020 14:40 0IggyMarie0

There is a mixing chamber connected with a valve. The chamber has two inlets and one exits. Liquid water at 200 kPa and 20 °C is heated in a chamber by mixing it with superheated steam at 200 kPa and 200 °C. Liquid water enters the mixing chamber at a rate of 2.5 kg/s, and the chamber is estimated to lose heat to the surrounding air at a rate of 1200 kJ/min. The mixture leaves the mixing chamber at 200 kPa and 70 °C. Assume steady state and ignore kinetic and potential energy effects. Assume there is no work or heat involved in the valve. Required:
a. If take the mixing chamber as the control volume, please list the simplified energy conservation equation for this CV.
b. If taking the mixing chamber and the valve as the combined control volume, please list the simplified energy conservation equation for this CV (leave it in symbolic form).
c. What is the mass flow rate at state 2?
d. There is a valve at the exit of the chamber to reduce the pressure to 20 kPa, determine the temperature at the exit of the valve

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

You know the right answer?

There is a mixing chamber connected with a valve. The chamber has two inlets and one exits. Liquid w...

Questions