Engineering, 25.11.2020 14:00 wrightdarius78

A silicone polymer film of 4 mm thickness coats a flat, nonporous, inert surface. The polymer film is exposed to stagnant 100% O2 gas maintained at 1.5 atm. Oxygen gas is sparingly soluble in the silicone polymer film, with the solubility relationship given by Ca = S* Pa with S = 3:16 g mol O2/m3 silicone atm O2 at 298 K. Initially, there is 0.39 g mol O2/m3 uniformly dissolved in the film. The diffusion coefficient of O2 in silicone is 1 × 10-11 m2/s at 298 K. a. At a very short time of 10 s, O2 does not penetrate very far into the silicone polymer film. Under this physical situation, what is the flux of O2 into the surface of the silicone polymer film at this time? b. At a much longer time, the dissolved O2 concentration in the silicone polymer film at the polymer/inert interface is now 3.0 g mol/m3. How long will it take to achieve this concentration?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

A silicone polymer film of 4 mm thickness coats a flat, nonporous, inert surface. The polymer film i...

Questions