subject
Engineering, 21.11.2020 19:40 cia196785920

Marcie observes a boat floating on water and tries to explain to her mother why the boat is not moving. Which of the following explanations is the best to use? A. The force of gravity acting on the boat is the same as the force of the water pushing up. This means the forces acting on the boat are balanced. B. The force of gravity acting on the boat is the same as the force of the water pushing up. C. This means the forces are unbalanced. The force of the water pushing up on the boat is greater than the force of gravity pulling the boat down. This means the forces acting on the boat are balanced. D. The force of the water pushing up on the boat and the force of the boat pushing itself up allows the boat to float. The two forces are balanced.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
question
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
question
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You know the right answer?
Marcie observes a boat floating on water and tries to explain to her mother why the boat is not movi...
Questions
Questions on the website: 13722360