Engineering, 20.11.2020 14:00 clairebear65
Waterjet cutting uses a . a) Very-small-diameter jet of water that exits the cutting nozzle at approximately the speed of sound. b) Diamond cutting wire cooled by a waterjet which also carries away the composite material as a slurry. c) Very-small-focused-stream of water that oscillates at 20,000 cycles per second.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
You know the right answer?
Waterjet cutting uses a . a) Very-small-diameter jet of water that exits the cutting nozzle at appro...
Questions
Mathematics, 13.03.2020 00:10
Mathematics, 13.03.2020 00:11
Mathematics, 13.03.2020 00:11
