subject
Engineering, 20.11.2020 03:30 helloitschump0vfdz

Why, do you suppose, an architect must have a minimum of a bachelor’s degree, be licensed in every state, and often encouraged to pursue advanced degrees or additional professional training? Select all that apply. Architects must maintain a level of professional care and attention to detail that assures their designs meet with accepted standards.

The licensing provisions for architects typically require a minimum of a bachelor’s degree in design and related coursework to assure all graduates have approximately equal training and knowledge.

Technology continues to influence building design by making it possible to produce new, stronger building materials and architects must be aware of the use and limitations of new materials.

Architects need not have a bachelor’s degree; many become licensed through apprentice programs.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
You know the right answer?
Why, do you suppose, an architect must have a minimum of a bachelor’s degree, be licensed in every s...
Questions
question
Mathematics, 06.05.2020 08:20
question
Mathematics, 06.05.2020 08:20
question
Mathematics, 06.05.2020 08:20
question
Chemistry, 06.05.2020 08:20
Questions on the website: 13722360