Engineering, 18.11.2020 17:30 alwaysneedhelp8420

Missiles with onboard radars must use durable high-temperature materials for the radome, which is the term for the covering that protects a radar or other type of antenna. One material that can be used for a high-temperature radome is alumina, a ceramic (A1,02), which has a relative permittivity of E, = 9.6 at a frequency of f = 26 GHz. Alumina is non-magnetic (u, = 1). (a) Calculate the wave impedance n of alumina (the ratio of the electric-field magnitude to the magnetic field magnitude) at 26 GHz. (b) What is the propagation constant B of a TEM wave in alumina at f = 26 GHz? (c) As you will find later in the course, a slab of lossless dielectric material one-half- wave thick can transmit essentially all of the TEM-wave energy normally incident upon it. If you wish to make a half-wave-thick radome sheet out of alumina at 26 GHz, how thick must it be? Express your answer in mm.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air compression refrigeration system is to have an air pressure of 100 psia in the brine tank and an allowable air temperature increase of 60°f for standard vapor compression cycle temperatures of 77 f entering the expansion cylinder and 14 f entering the compression cylinder, calculate the coefficient of performance a. 2.5 b 3.3 c. 4.0 d. 5.0

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

Missiles with onboard radars must use durable high-temperature materials for the radome, which is th...

Questions