subject
Engineering, 18.11.2020 04:50 claudioocampo5621

Tech A says that no matter which way the vehicle turns, the inside wheel must always turn less sharply than the outside wheel. Tech B says that the Ackermann principle angles the steering arms toward the center of the rear axle. Who is correct?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Burgers vector is generally parallel to the dislocation line. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
You know the right answer?
Tech A says that no matter which way the vehicle turns, the inside wheel must always turn less sharp...
Questions
question
Mathematics, 22.02.2021 08:20
question
Chemistry, 22.02.2021 08:30
question
Mathematics, 22.02.2021 08:30
question
Mathematics, 22.02.2021 08:30
Questions on the website: 13722363