subject
Engineering, 11.11.2020 17:50 LaneyMM1401

We want to assess how far engine designed/manufacturers have progressed over the last 100 years. Consider the Ford Model T, the first mass produced automobile which began production in 1908. With the equipped engine, the Model T was capable of a max speed of 45 mph. Engine Model TBore [mm] 95.25Stroke [mm] 101.6Comp. Ratio [-] 3.98Power [hP] 20Speed [rpm] 1750Config. I4Induction Nat. Asp. Fuel Gasoline Cycle 4-Stroke1. Ford claims the Model T achieved fuel economy on the order of 13-21 mpg. Assuming the average of this range (i. e. 17 mpg), determine the fuel consumption in [gal/hr] of the engine at the maximum vehicle speed of 45 mph.2. Calculate the brake specific fuel consumption in [g/kW-hr] at rated power and max vehicle speed. (rhogasoline = 0.75 g/mL, 1 gal = 3785.4 mL, 1 hP = 0.7457 kW).3. If the heating value of gasoline is 42 MJ/kg, and given the answer to the previous part, determine the brake efficiency at these operatingconditions.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
You know the right answer?
We want to assess how far engine designed/manufacturers have progressed over the last 100 years. Con...
Questions
Questions on the website: 13722361