Engineering, 07.11.2020 20:40 anabelleacunamu
An attic truss is a steeply angled truss that carves out living space between its two top chords. It is commonly used for gable-roof homes with attic living spaces. Why would gables often be used for an attic truss?
Using gables allows for the use of a bottom chord.
Gables help make the construction less expensive.
The roof peak would be too steep without gables.
The living space would be extremely narrow without gables.
Answers: 1
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
An attic truss is a steeply angled truss that carves out living space between its two top chords. It...
Biology, 02.10.2021 04:10
Chemistry, 02.10.2021 04:10
Mathematics, 02.10.2021 04:10
Physics, 02.10.2021 04:10
Biology, 02.10.2021 04:10
Biology, 02.10.2021 04:10
Chemistry, 02.10.2021 04:10
Social Studies, 02.10.2021 04:10
Mathematics, 02.10.2021 04:10
Biology, 02.10.2021 04:10