Engineering, 06.11.2020 02:50 escojo2508
If a weld is laying into a joint with a concave weld contour with undercutting issues, what might be the cause?
A. Spatter build up on the gun parts
B. Not enough gel applied to the top
C. Base metal in not cooled properly
D. Voltage of the machine is set too high
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
Engineering, 04.07.2019 19:10
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
You know the right answer?
If a weld is laying into a joint with a concave weld contour with undercutting issues, what might be...
Questions
Mathematics, 25.06.2019 07:50
Arts, 25.06.2019 07:50
English, 25.06.2019 07:50
Social Studies, 25.06.2019 07:50
Business, 25.06.2019 07:50
Computers and Technology, 25.06.2019 07:50
