subject
Engineering, 05.11.2020 16:40 nyny679

Dexter Industries purchased packaging equipment on January 8 for $72,000. The equipment was expected to have a useful life of three years, or 18,000 operating hours, and a residual value of $3,600. The equipment was used for 7,200 hours during Year 1, 5,400 hours in Year 2, and 5,400 hours in Year 3. Required: 1. Determine the amount of depreciation expense for the three years ending December 31, by (a) the straight-line method, (b) the units-of-activity method, and (c) the double-declining-balance method. Also determine the total depreciation expense for the three years by each method. Round the final answers for each year to the nearest whole dollar.1) Find the force transmitted by the coupling between the nozzle and hose. 2) Indicate whether the coupling is in tension or compression. 3) Find the velocity of water flowing through the hose.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 18:10
Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.
Answers: 3
question
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
question
Engineering, 06.07.2019 04:10
Along steel shaft of 10 cm diameter is austenised at 870°c and then quenched in a liquid at 30oc. the average surface heat transfer coefficient is 2000 w/m2. °c. the relevant thermophysical properties of the shaft are: p=7800 kg/m", k=20 w/mk, cp=0.46 kj/kg.k calculate: a)-the time required for the center temperature to drop to 200°c. b)-the temperature at half-radius at that moment. c)-the amount of heat that had been transferred to the liquid by that time per meter length of the shaft
Answers: 1
You know the right answer?
Dexter Industries purchased packaging equipment on January 8 for $72,000. The equipment was expected...
Questions
question
Mathematics, 02.09.2019 07:20
question
Social Studies, 02.09.2019 07:20
Questions on the website: 13722361