Engineering, 29.10.2020 16:50 melonmanthree
Can someone PLEASE answer these? I have no idea what I'm doing. It's unit conversion for engineering. 1) 0.65 feet to inches. 2) 8 ft 2 ½ in. To inches 3) 6 ft 5 inches to decimal feet 4) 49.2 cm to inches. Thanks!
Answers: 3
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
Can someone PLEASE answer these? I have no idea what I'm doing. It's unit conversion for engineering...
Mathematics, 20.05.2021 21:30
Mathematics, 20.05.2021 21:30
Mathematics, 20.05.2021 21:30
Mathematics, 20.05.2021 21:30
Mathematics, 20.05.2021 21:30
Mathematics, 20.05.2021 21:30
History, 20.05.2021 21:30
Mathematics, 20.05.2021 21:30
Computers and Technology, 20.05.2021 21:30
English, 20.05.2021 21:30
History, 20.05.2021 21:30