Every lever must have a support point called a:
groove
fulcrum
pitch
l...
Engineering, 28.10.2020 20:10 fayth8312
Every lever must have a support point called a:
groove
fulcrum
pitch
load
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
You know the right answer?
Questions
Mathematics, 24.06.2020 17:01
Mathematics, 24.06.2020 17:01
Computers and Technology, 24.06.2020 17:01
Chemistry, 24.06.2020 17:01
Mathematics, 24.06.2020 17:01
Mathematics, 24.06.2020 17:01
