Engineering, 28.10.2020 17:50 oomale
Can anyone help??? This was due yesterday??? This is welding!
If the questions aren't clear then here they are.
1.) The step motion (we call it the stitch motion), is used with what type of welding electrodes?
2.) What type of penetration is gained by using the step motion technique?
3.) A vertical weld can be made in which directions?
4.) Which vertical technique is the easiest to perform?
5.) What technique or motion is used when welding in the horizontal position?
6.) 6013 electrodes were designed to weld; what material, in what polarity, while traveling in what direction?
7.) What is the recommended amperage to be used when welding a โ
โ 6013 electrode in AC?
8.) If you make a small weld, what can be done to correct this problem according to the video?
9.) What solidifies first when welding with 7018, the poodle or the flux?
10.) What is porosity?
11.) What can cause porosity?
12.) When using a โ
โ 7018 electrode in DC+, when is the suggested amperage?
Answers: 3
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10รค1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
Can anyone help??? This was due yesterday??? This is welding!
If the questions aren't clear then he...
Mathematics, 14.01.2021 22:40
Mathematics, 14.01.2021 22:40
Chemistry, 14.01.2021 22:40
Chemistry, 14.01.2021 22:40
Social Studies, 14.01.2021 22:40
Health, 14.01.2021 22:40
Mathematics, 14.01.2021 22:40
History, 14.01.2021 22:40
Mathematics, 14.01.2021 22:40
Social Studies, 14.01.2021 22:40
History, 14.01.2021 22:40