subject
Engineering, 23.10.2020 15:40 RiddleMeThis

The wind tunnel is designed so that the lower pressure outside the testing region B draws air out in order to reduce the boundary layer. Within region B there are 1000 holes, each 4 mm in diameter. If the pressure is adjusted so that the average velocity of the air through each hole is 10 m/s, determine the average velocity of the air exiting the tunnel at C. (Assume the air is incompressible).

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
You know the right answer?
The wind tunnel is designed so that the lower pressure outside the testing region B draws air out in...
Questions
question
Mathematics, 30.09.2019 00:00
question
Mathematics, 30.09.2019 00:00
question
Mathematics, 30.09.2019 00:00
Questions on the website: 13722367