3) In the below power cycle, 25 kg/s of steam at 3 MPa and 500C enters the turbine. The condenser temperature is 35C. The plant operates with an open Feed Water Heater (FWH), where the water leaves as saturated liquid at 200 kPa before entering the second pump: [9points] a) Find the extraction flow rate (y). b) Find the total turbine work

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.