Engineering, 18.10.2020 14:01 jonquil201

Education This is a good place to talk about the degree and training necessary to become this engineer. Also show the three colleges that you found that this degree is available.
College 1:
College 2:
College 3:

Skills and Abilities
This is a good place to talk about the necessary skills and abilities that are required of and necessary to be in this field of engineering. How do these necessary skills benefit this type of engineer?
Personal Opinion\
Why do you like this field?

Salary and Companies
This is a good place where you can put the average salary for this type of engineer. Also make a list to show the three companies that you found to be in need of this type of engineer. You can show company logos as well.
Company 1
Company 2
Company 3

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 05.07.2019 19:10

Tech a says never use a water hose to clean up dust after a repair. tech b says never use a floor scrubber to clean up dust after repairs. who is correct?

Answers: 1

Answer

Engineering, 06.07.2019 03:10

An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.

Answers: 1

Answer

Engineering, 06.07.2019 04:10

Aheat pump with refrigerant-134a as the working fluid is used to keep a space at 25°c by absorbing heat from geothermal water that enters the evaporator at 500c at a rate of 0.065 kg/s and leaves at 40°c. the refrigerant enters the evaporator at 20°c with a quality of 23 percent and leaves at the inlet pressure as saturated vapor. the refrigerant loses 300 w of heat to the surroundings as it flows through the compressor and the refrigerant leaves the compressor at 1.4 mpa at the same entropy as the inlet. determine: (a) the degrees of subcooling of the refrigerant in the condenser, b)-the mass flow rate of the refrigerant . (c) the heating load and the cop of the pump, and d)-the theoretical minimum power input to the compressor for the same heating load.

Answers: 3

Answer

You know the right answer?

Education This is a good place to talk about the degree and training necessary to become this engi...

Questions