Engineering, 16.10.2020 23:01 whitewesley124

Pls, Help. This is for Engineering Science Procedure
You will design and create a simulated electrical energy distribution system. Successful system design will demonstrate strategic power distribution to meet the demand of residential consumers.
The resistor simulates losses in energy due to transferring energy from the power plant to the residential consumers.
Each LED represents one household in the city. Design a circuit to provide power to the maximum number of households.

Design Constraints
The battery must be connected in series with the resistor in the circuit followed by the LEDs in any configuration you determine to be the most desirable.
Check with your teacher for the amount of time allowed (always remember the time constraint even if not listed).
Do on TinkerCAD

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Around steel bar, made from material with a yield stress of 750mpa, is loaded so that it has stresses co locations of maximum normal stress and maximum shear stress. use maximum shear stress and maximum distortion energy theories to calculate the safety factors for initial yielding failures.

Answers: 3

Answer

You know the right answer?

Pls, Help. This is for Engineering Science Procedure
You will design and create a simulated e...

Questions