Engineering, 16.10.2020 19:01 mari5512

Four helical compression springs are being designed to support a 200 lbf load. The springs will be placed at each of four corners, and will share the load equally. The springs will each be compressed 1 inch from the free length. The solid height cannot exceed 2 inches, and the free length cannot exceed 4 inches. Springs will be as wound, and they will be manufactured in volume. Squared and ground ends will be used. Do not specify wire diameters with precision beyond 1/100 of an inch. A static factor of safety of 1.2 will be applied to the solid height of the spring, and a fractional overrun to closure value ( 8 ) of 0.15 will be used to ensure robust linearity. The spring material will be music wire (ASTM A228-51).

Required:
Design the springs, including FOM using MATLAB.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

You know the right answer?

Four helical compression springs are being designed to support a 200 lbf load. The springs will be p...

Questions