Engineering, 16.10.2020 08:01 mothertrucker2828

Fueloil containing a mixture of 90 mol% propane and the rest carbon disulfide is burned to completion in 150% excess air inside a furnace. The furnace exhaust gas passes through a scrubber, where 95% of the CO2 entering is absorbed in ammoniated water and removed. In addition, some water vapor in the combustion product is condensed. Everything else exits the scrubber in the overhead gas, which is split into two streamsafter leaving the scrubber: one stream is recycled and mixed with fresh combustion gases from the furnace before entering the scrubber; the other stream is passed to a tall stack. Assume the combustion products are SO2, CO2, and H2O. Required:
a. Why do you think some of the scrubber overhead gas is recycled?
b. Draw a fully-labeled process flow diagram. If it is possible to calculate the feed rate of ammoniated water to the scrubber, do so.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

Fueloil containing a mixture of 90 mol% propane and the rest carbon disulfide is burned to completio...

Questions