Engineering, 16.10.2020 07:01 ldpozorski

State whether the following statements are true or false. Provide a brief justification for your answer. a. Consider a SDOF system with Coulomb damping. When displaced from the equilibrium position and released, the mass may not move at all.
b. Consider a SDOF system with an ideal viscous damper. When displaced from the equilibrium position and released, the mass will always undergo oscillatory motion.
c. The damped natural frequency of a system is always greater than the undamped natural frequency
d. For an undamped system undergoing a harmonic forcing, the amplitude of the response approaches zero as the forcing frequency becomes very high.
e. The amplitude of free response of SDOF system with Coulomb damping decreases

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

State whether the following statements are true or false. Provide a brief justification for your ans...

Questions