Engineering, 14.10.2020 01:01 dunqueeezy6295
When an inside corner is being welded in the horizontal position, undercutting can be decreased or prevented by .
stopping momentarily at the edges of the weld
using a forward-inclined, half-moon torch motion
placing the welding rod in the upper edge of the weld pool
All of the above.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
Engineering, 05.07.2019 23:20
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
You know the right answer?
When an inside corner is being welded in the horizontal position, undercutting can be decreased or p...
Questions
Social Studies, 25.10.2019 18:43
Mathematics, 25.10.2019 18:43
Chemistry, 25.10.2019 18:43
Mathematics, 25.10.2019 18:43
History, 25.10.2019 18:43
Social Studies, 25.10.2019 18:43
English, 25.10.2019 18:43
