The tolerance for a geometric can be easily identified by reading the .
A. Datum
B. Baseline<...
Engineering, 13.10.2020 07:01 Svetakotok
The tolerance for a geometric can be easily identified by reading the .
A. Datum
B. Baseline
C. Dimension
D. Feature control frame
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
Questions
Geography, 22.02.2021 07:30
Mathematics, 22.02.2021 07:30
Mathematics, 22.02.2021 07:30
Mathematics, 22.02.2021 07:30
Business, 22.02.2021 07:30
Mathematics, 22.02.2021 07:30
Mathematics, 22.02.2021 07:30
Biology, 22.02.2021 07:30
Health, 22.02.2021 07:30
Mathematics, 22.02.2021 07:30
History, 22.02.2021 07:30
