Engineering, 13.10.2020 04:01 darianhaynes

Rod 1 is made of steel, E1 = 210 GPa, α_1 = 12.5 x 10-6 °C-1, A1 = 30 cm2. Rod 2 is made of brass, E2 = 105 GPa, α_2 = 19 x 10-6 °C-1, A2 = 30 cm2. AB is a rigid member connected to a pin support at its center, and is horizontal initially. Then a load F = 50 kN is applied. To counteract deformations caused by the applied force, the temperature is also changed by ∆T to force AB to stay at its initial position. (a) Does the temperature of the system increase or decrease? (b) What is the magnitude of the temperature change ∆T?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

Answer

Engineering, 04.07.2019 19:10

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.

Answers: 2

Answer

You know the right answer?

Rod 1 is made of steel, E1 = 210 GPa, α_1 = 12.5 x 10-6 °C-1, A1 = 30 cm2. Rod 2 is made of brass, E...

Questions