Engineering, 02.10.2020 09:01 gggggggggggg5496
A student is measuring the effects of an electric circuit on a compass, and he is testing to see if increasing the current will cause the compass needle to change its direction faster. He does one trial using a 9-volt battery and another trial using a 1.5-volt battery. He takes accurate data. Based on good experimental design, what would improve his experiment?
A) He should repeat the test with three additional batteries of varying voltages to demonstrate the reproducibility of results.
B) He should use only one battery but do several trials, using different circuit designs to ensure he has appropriate test groups.
C) He should add a nonworking compass to act as a control.
D) He should use batteries of the same voltage but from different manufacturers to show he has used different variables.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
A student is measuring the effects of an electric circuit on a compass, and he is testing to see if...
Questions
Mathematics, 14.07.2019 19:00
Computers and Technology, 14.07.2019 19:00
English, 14.07.2019 19:00
English, 14.07.2019 19:00
Mathematics, 14.07.2019 19:00
Computers and Technology, 14.07.2019 19:00
Biology, 14.07.2019 19:00
