Engineering, 25.09.2020 05:01 marinahuntg
Find the engine volume and compression ratio from the paper. Use those numbers to calculate the following and list any assumptions you make about the cycle in your document. Assume that air has γ-1.4 and R-287 J/kgK. and the engine is running an air-standard ideal Otto cycle.
a) Indicated work produced each cycle (in Joules)
b) Heat addition each cycle (in Joules) - assume the engine runs off gasoline with a lower heating value of 42 MJ/kg and air-to-fuel ratio of 14.7 (stoichiometric for gasoline). The lower heating value is the amount of heat generated from the combustion of a liquid fuel per unit mass.
c) Indicated thermal efficiency of the engine.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
You know the right answer?
Find the engine volume and compression ratio from the paper. Use those numbers to calculate the foll...
Questions
