Tiny hydrogen bubbles are being used as tracers to visualize a flow. All the bubbles are generated at the origin (x = 0, y = 0). The velocity is unsteady and obeys the equations: u = 1 m/s v = 2 m/s 0 ≤ t < 2 s u = 0 m/s v = −1 m/s 2 s ≤ t ≤ 4 s Plot the pathlines of bubbles that leave the origin at t = 0, 1, 2, 3, and 4 s. Mark the locations of these five bubbles at t = 4 s. Use a dashed line to indicate the position of a streakline at t = 4 s

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.