subject
Engineering, 23.09.2020 14:01 josephmcintosh3137

An asbestos pad is square in cross section, measuring 5 cm on a side at its small end, increasing linearly to 10 cm on a side at the large end. The pad is 15 cm high. The small end is held at 600 K and the large end at 300 K. Assuming one-dimensional heatconduction. What heat-flow rate will be obtained if the four sides areperfectlyinsulated andthe thermal conductivity of asbestos is:

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
question
Engineering, 04.07.2019 19:10
Asteel wire of 2 mm diameter is fixed between two points located 2 m apart. the tensile force in the wire is 250n, if its density of steel is given by 7830 kg/m3 the fundamental frequency of vibration hz? ?
Answers: 3
question
Engineering, 04.07.2019 19:10
Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.
Answers: 2
You know the right answer?
An asbestos pad is square in cross section, measuring 5 cm on a side at its small end, increasing li...
Questions
question
English, 30.11.2020 16:50
question
Mathematics, 30.11.2020 16:50
question
Mathematics, 30.11.2020 16:50
Questions on the website: 13722360