Engineering, 22.09.2020 03:01 nimahmustafa

Mass spectral measurements were made on 10 replicate low concentration Cu-EDTA samples: 173.7 , 130.0 , 146.3 , 161.3 , 130.3 , 199.7 , 151.3 , 155.9 , 145.3 , and 162.9 counts. Ten measurements of a blank had a mean measurement of 25.1 counts. A sample containing 3.00 μM Cu-EDTA gave a measurement of 1679 counts. Estimate the signal and detection limit for Cu-EDTA. Signal detection limit: counts
Concentration detection limit: μM

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

You know the right answer?

Mass spectral measurements were made on 10 replicate low concentration Cu-EDTA samples: 173.7 , 130....

Questions