Engineering, 21.09.2020 14:01 northpolea
Which statement best describes how scientists and engineers work together
in the research and development cycle?
A. Scientists develop a new technology, and then engineers test it by
doing experiments.
B. Engineers make a scientific discovery, and then scientists perform
research to verify it.
C. Scientists test designs made by engineers and then use the
results to improve the designs.
D. Engineers come up with scientific questions when they are
developing their design, and scientists do research to answer
them.
(this is for apex. i’d love if you could help me <33)
Answers: 2
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
Which statement best describes how scientists and engineers work together
in the research and devel...
Chemistry, 17.11.2021 16:20
Mathematics, 17.11.2021 16:20
Biology, 17.11.2021 16:20
Mathematics, 17.11.2021 16:20
English, 17.11.2021 16:20
Mathematics, 17.11.2021 16:20
English, 17.11.2021 16:20