A cold-drawn AISI 1015 steel tube is 300 mm OD by 200 mm ID and will be shrink fit inside another tube, resulting in an external pressure. Using DE, determine the maximum pressure that would cause the material of the tube to yield. Hint: This is stress in a pressurized cylinder (section 3-14), with zero internal pressure and an external pressure that we are meant to find. :g

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

The higher the astm grain size number, the finer the gran is. a)-true b)-false

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature