Engineering, 10.09.2020 04:01 Thejollyhellhound20

Q.4. Two thermocouples (temperature measurement devices) are tested by inserting their probes in boil- ing water, recording the readings, removing and drying the probes, and then doing it again. The results of five measurements are as follows: T(°C)-Thermocouple A | 72.4 | 73.1 | 72.6 72.8 | 73.0 T(C) Thermocouple B 973 1014 98.701100.4 (a) For each set of temperature readings, calculate the sample mean, the range, and the sample (b) Which thermocoupie readings exhibit the higher degree of scatter? Which thermocouple is more standard deviation. accurate?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

You know the right answer?

Q.4. Two thermocouples (temperature measurement devices) are tested by inserting their probes in boi...

Questions