Engineering, 21.08.2020 16:01 carlossauceda0

Water that has a salt concentration of 12500 mg salt/Liter water is fed into a unit (U1) that can reduce the concentration of the salt. The outputs of this unit are a concentrated stream, and a diluted stream with salt concentration of 100 mg/L water. In order to obtain a water with a salt concentration of 500 mg/L water, a by-pass stream is used, where the by-pass stream is mixed with the diluted stream output of the unit (U1). If the fresh feed has a volumetric flow rate of 100L/min, and the concentrated stream accounts to 75% of the fresh feed.

Sketch fully detailed flow-chart of the process
Determine the NDF of at least three control volumes.
Calculate the concentration of the salt in the concentrated stream
Calculate the mass flowrate of water that has a salt concentration of 500 mg/L water
If the mass flowrate of water that has a salt concentration of 500 mg/L water is needed to be 340 g/min, calculate the mass flowrate of the fresh feed.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Explain the strain-hardening phenomenon on the basis of dislocation - dislocation strain field interactions. also, briefly describe what generally happens to the ductility of a metal that has been strain hardened (i.e. does strain hardening make a metal more ductile or

Answers: 3

Answer

You know the right answer?

Water that has a salt concentration of 12500 mg salt/Liter water is fed into a unit (U1) that can re...

Questions