Qu. 08-18 Design a double-dwell cam to move a... Design a double-dwell cam to move a follower from 0 to 2.5 in. in 60°, dwell for 120°, fall 2.5 in. in 30°, and dwell for the remainder. The total cycle must take 4 sec. Size the cam for a 1-in. radius roller follower considering pressure angle and radius of curvature. Use eccentricity only if necessary to balance these functions. Plot both these functions. Draw the cam profile. Repeat this for a flat-faced follower. Which one would you use?

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.