Engineering, 16.08.2020 01:01 morrisjillian23
Technician A says that cut locations for sectioning joints may be identified by a die mark stamped into the part. Technician B says that a vehicle maker recommended sectioning cut location may be identified as a precise measurement from a reference point. Who is right
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms
Answers: 2
Engineering, 04.07.2019 19:10
A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?
Answers: 3
You know the right answer?
Technician A says that cut locations for sectioning joints may be identified by a die mark stamped i...
Questions
Arts, 19.10.2020 19:01
Computers and Technology, 19.10.2020 19:01
Social Studies, 19.10.2020 19:01
Mathematics, 19.10.2020 19:01
Mathematics, 19.10.2020 19:01
