subject
Engineering, 05.08.2020 18:01 Jolenesopalski

Multiple Unit Material balance problem A feed containing equimolar amounts of methanol and water is mixed with 10 moles of a 40 % mol aqueous methanol stream. The mixture enters a first separation unit that creates two streams. A top stream exits the separation unit that contains 70 % mol methanol and rest water. The bottom stream, which is 70 moles enters a second separation unit. A top stream exists the second separation unit as a 50 % methanol & 50 % water mixture. The other stream is unknown. If the fresh feed to the system is 100 moles (equimolar mixture) and the two top streams exiting the separation units have the same flow, draw the flow sheet and find the molar flow and the composition of the bottom streams existing the second separation unit?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
You know the right answer?
Multiple Unit Material balance problem A feed containing equimolar amounts of methanol and water is...
Questions
question
Mathematics, 04.08.2020 18:01
question
Mathematics, 04.08.2020 18:01
question
Mathematics, 04.08.2020 18:01
Questions on the website: 13722367