Engineering, 04.08.2020 04:01 ayoismeisalex
Given the following scalar potentials (V), calculate the solution for the gradient of V (∇V), and plot the vector arrow representation of this vector field over the given limits. a. V = 15+ r cosΦ, for 0 <= r <= 10, and 0 <= Φ 2π. b. V = 100+ xy, for -- 10 <= x <=10
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Given the following scalar potentials (V), calculate the solution for the gradient of V (∇V), and pl...
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Biology, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Biology, 19.11.2019 05:31
Computers and Technology, 19.11.2019 05:31
Social Studies, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31
Mathematics, 19.11.2019 05:31