Engineering, 22.07.2020 01:01 adantrujillo1234

A steady mass flow rate (m1) of superheated steam flows through a turbine used in a power plant to drive an electric generator. The superheated steam enters the adiabatic turbine at a pressure of P1 and a temperature of T1. The steam expands in the turbine until it exits at a pressure of P2. The turbine has an isentropic efficiency of N . Determine the following given the properties listed below. m1(kg/s) = 45
P1(MPa) = 10
T1(C) = 525
P2(bar) = 0.4
N(%) = 80
1. Determine the specific enthalpy (kJ/kg) at the turbine inlet.
2. Determine the specific entropy (kJ/kg) at the turbine inlet.
3. Determine the specific enthalpy (kJ/kg) at the turbine exit if the turbine was isentropic.
4. Determine the actual specific enthalpy (kJ/kg) at the turbine exit.
5. Determine the power output (MW) of the turbine.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

A steady mass flow rate (m1) of superheated steam flows through a turbine used in a power plant to d...

Questions