Engineering, 08.07.2020 21:01 DEJAHHARRIS6055

Engineers are considering two possible vessel shapes for storing fuel. One shape is cylindrical and the other is spherical. Each vessel would be constructed out of the same material such that its hoop stresses and longitudinal stresses would be no greater than 17.0 ksi . The cylindrical pressure vessel has an inside diameter of dc = 28.0in and a thickness oftc = 1.00in . The spherical pressure vessel has an inside diameter of ds = 30.0in and a thickness of ts = 0.750in .Part A - Maximum allowable pressure in the cylindrical pressure vesselDetermine the maximum allowable pressure, pc, max, in the cylindrical pressure vessel. Part B - Maximum allowable pressure in the spherical pressure vesselDetermine the maximum allowable pressure, ps, max, in the spherical pressure vessel. Part C - Required thickness of the cylindrical pressure vessel for maximum pressure equivalencyDetermine the required thickness of the cylindrical pressure vessel, tr, if it is subjected to the maximum allowable pressure of the spherical pressure vessel that was calculated in Part B.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference

Answers: 3

Answer

Engineering, 06.07.2019 02:30

Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers

Answers: 3

Answer

You know the right answer?

Engineers are considering two possible vessel shapes for storing fuel. One shape is cylindrical and...

Questions