Engineering, 05.07.2020 14:01 bsmith892341

Suppose that you want to freeze 1 kg of water for a party, and only have 5 minutes to do it. Relying on nothing but your keen physical abilities, a dixicup, duct tape and a piece of string, you manage to build a refrigerator unit which can do the job. The temperature inside the refrigeration unit is 273 K, and the temperature outside is 350 K. Since you are a brilliant UIUC student, assume that your refrigerator has the maximum possible efficiency. The Latent Heat of Fusion of water is 3.33Ã—10^5 J/kgAssume that the initial temperature of the water is 273 K. Requried:a. What is the change (including the sign) in entropy in the water per second in J/(Ks)?b. What is the heat flow ( Q_hot/time ) into the Hot well per second in J/s?c. How much power must you provide to drive your refrigerator in Watt W? (That is work done per second?)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

You know the right answer?

Suppose that you want to freeze 1 kg of water for a party, and only have 5 minutes to do it. Relying...

Questions