subject
Engineering, 05.07.2020 14:01 alex12everett

An electron is traveling with initial kinetic energy K in a uniform electric field. The electron comes to rest momentarily after traveling a distance d. a. What is the magnitude of the electric field? b. What is the direction of the electric field? 1. In the direction of the electron's motion. 2. Opposite to the direction of the electron's motion. 3. Perpendicular to the direction of the electron's motionc. What If? Fluoride ions (which have the same charge as an electron) are initially moving with the same speed as the electrons from part (a) through a different uniform electric field. The ions come to a stop in the same distance d. Let the mass of an ion be M and the mass of an electron be m. Find the ratio of the magnitude of electric field the ions travel through to the magnitude of the electric field found in part (a). (Use the following as necessary: d, K, m, M, and e for the charge of the electron.)

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
question
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
question
Engineering, 04.07.2019 19:20
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
You know the right answer?
An electron is traveling with initial kinetic energy K in a uniform electric field. The electron com...
Questions
Questions on the website: 13722360