subject
Engineering, 03.07.2020 14:01 cheervolley

It is known that after the concrete is adjusted by trial mixing, the amount of various materials is: cement 3.10kg, water 1.86kg, sand 6.24kg, crushed stone 12.8kg, and the apparent density of the mixture is 2500kg βˆ• m3 . : (1)How much is the amount of per cube concrete material? (2)If the moisture content of sand at the construction site is 2.5%, and the moisture content of stone is 0.5%, find the construction mix ratio.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
It is known that after the concrete is adjusted by trial mixing, the amount of various materials is:...
Questions
question
Mathematics, 18.03.2021 01:10
question
Mathematics, 18.03.2021 01:10
question
Mathematics, 18.03.2021 01:10
question
English, 18.03.2021 01:10
question
Mathematics, 18.03.2021 01:10
question
Mathematics, 18.03.2021 01:10
question
Mathematics, 18.03.2021 01:10
question
Mathematics, 18.03.2021 01:10
question
Mathematics, 18.03.2021 01:10
Questions on the website: 13722362