Engineering, 01.07.2020 15:01 tordiacasey

Consider the precipitation of a spherical B-rich phase (phase) from a dilute solution ( phase) of B in A. Suppose the original concentration of B in the solid solution is Co-5x10 atoms/cm', the diffusion coefficient of B is D-1010 cm/sec, and the interface transfer parameter of B is M-106 cm/sec. In a quasi-steady state, if the averaged concentration of B in the bulk (C) remains approximately the same as Co. and the concentration of B next to the auß interface is C 4x10 atoms/cm. what are the equilibrium concentration of B in the and the phases (Ca and Cb), when 21 the radius of the particle is r-um: 104 cm and grows at a rate (ar) of 10-7 cm/sec?

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

You know the right answer?

Consider the precipitation of a spherical B-rich phase (phase) from a dilute solution ( phase) of B...

Questions