Engineering, 21.06.2020 03:57 ncosmebaez15

A) mi(t) = sin(2007) b) m2(t) = sinc(100nt)
c) m3(t) = e-||
d) m4(t) = I14.05)
e) m5(t) = A(-0.5)
You will perform demodulation of Only ONE message signal among the five described above, which will depend on the last digit of your student ID. Your message signal is determined as mk(t) where k = ( [the last digit of your student ID] mod 5 + 1).
Your demodulator consists of multiplier of carrier signal followed by a low pass filter (LPF). Implement MATLAB codes to realize this demodulation processing; and from this processing, plot the spectrum of the demodulated signal. Compare this with the original spectrum of the message.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.

Answers: 3

Answer

You know the right answer?

A) mi(t) = sin(2007) b) m2(t) = sinc(100nt)
c) m3(t) = e-||
d) m4(t) = I14.05)
e...

Questions