Engineering, 20.06.2020 03:57 mcalepcrager

Air at a temperature of 27.0°C (P = 1.00 atm) and a velocity of 12.7 m/sec flows over the top of a flat mold in order to cool it down (assume this is a flat plate). The mold has dimensions of 1.50 m wide by 0.450 m long (the 0.450 meters dimension is in the direction of the air flow); and is at a temperature of 127.0°C. a) Find the heat transfer rate from the mold to the air (q). b) Calculate the drag force on the mold due to the air flow.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

Air at a temperature of 27.0°C (P = 1.00 atm) and a velocity of 12.7 m/sec flows over the top of a f...

Questions