subject
Engineering, 17.06.2020 22:57 Abarrett7323

Terminal velocity of a falling ball: For objects falling through air, the drag law is not linear but quadratic. A ball of mass m is released from rest and falls through the air under gravity. Air resistance exerts a drag force with magnitude kv2 in a direction opposite to the velocity of the ball, with k being a constant. (a) Write down a force balance on the ball. What is the terminal velocity of the ball? (no need to solve differential equations to answer this) (b) Set up the differential equation for the velocity of the ball as a function of time v(t). Write down the the initial conditions. (c) Solve the differential equation in (b) for v(t). Check that your solution satisfies the initial conditions and approaches the terminal velocity you expect from (a) as t + 0. (Hint: You will need to use a partial fraction decomposition to solve.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
You know the right answer?
Terminal velocity of a falling ball: For objects falling through air, the drag law is not linear but...
Questions
question
Social Studies, 19.05.2021 16:50
Questions on the website: 13722363