Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 18:20
Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg
Answers: 2
You know the right answer?
Fixed fee with guaranteed maximum cost...
Questions
Mathematics, 22.04.2020 21:21
History, 22.04.2020 21:21
History, 22.04.2020 21:21
English, 22.04.2020 21:21
Mathematics, 22.04.2020 21:21
Mathematics, 22.04.2020 21:21
Mathematics, 22.04.2020 21:21
Mathematics, 22.04.2020 21:21
Mathematics, 22.04.2020 21:21
History, 22.04.2020 21:21
English, 22.04.2020 21:21
Mathematics, 22.04.2020 21:21
History, 22.04.2020 21:21
Mathematics, 22.04.2020 21:21
